Neutral position Position 1 (source 1) |
| No. | Name | Function |
|---|---|---|
| 1 | Power |
Green: The controller power is ON. OFF: The controller power is OFF. |
| 2 | Display screen |
Resolution: 240 x 128 px. Viewing area: 88.50 x 51.40 mm. Six lines, each with 25 characters. |
| 3 | Navigation | Move the selector up, down, left and right on the screen. |
| 4 | OK |
Go to the Menu system. Confirm the selection on the screen. |
| 5 | Back | Go to the previous page. |
| 6 | AUTO mode |
The controller automatically connects and disconnects the breakers. In genset applications, the controller also automatically starts and stops, the genset. No operator actions are needed. |
| 7 | Silence horn | Stops an alarm horn (if configured) and enters the Alarm menu. |
| 8 | Shortcut menu | Access the ATS priority selection, Jump menu, Mode selection, Lamp test. |
| 9 | SEMI-AUTO mode |
The operator or an external signal can connect or disconnect the breaker, and in genset applications, start and stop the genset. The controller cannot automatically connect or disconnect the breaker, or start and stop the genset. |
| 10 | Mains symbol | Green: Mains voltage and frequency are OK. The controller close the
breaker. Red: Mains failure. |
| 11 | Close breaker | Push to close the breaker. In genset applications, the genset is automatically started when you push this button before closing the breaker. |
| 12 | Open breaker | Push to open the breaker. In genset applications, the genset is automatically stopped wgen you push this button before opening the breaker. |
| 13 | Breaker symbols |
Green: Breaker is closed. Red: Position failure. |
| 14 | Generator | Green: Generator voltage and frequency are OK. The controller can
close the breaker. Green flashing: The generator voltage and frequency are OK, but the V&Hz OK timer is still running. The controller cannot close the breaker. Red: The generator voltage is too low to measure. |
| 15 | Engine | Green: There is running feedback. Green flashing: The engine is getting ready. Red: The engine is not running, or there is no running feedback. |
| 16 | Stop | Stops the genset if the controller is in SEMI-AUTO mode. |
| 17 | Start | Starts the genset if the controller is in SEMI-AUTO mode. |
| 18 | Load symbol |
Green: The supply voltage and frequency are OK. Red: Supply voltage/frequency failure. |