| No. | Name | Function |
|---|---|---|
| 1 | Power |
Green: The controller power is ON. OFF: The controller power is OFF. |
| 2 | Display screen |
Resolution: 240 x 128 px. Viewing area: 88.50 x 51.40 mm. Six lines, each with 25 characters. |
| 3 | Navigation | Move the selector up, down, left and right on the screen. |
| 4 | OK |
Go to the Menu system. Confirm the selection on the screen. |
| 5 | Back | Go to the previous page. |
| 6 | AUTO mode |
The controller automatically joins and splits the busbar, and connects and disconnects the breakers. No operator actions are needed. In genset applications, the controller also automatically starts and stops gensets. |
| 7 | Silence horn | Stops an alarm horn (if configured) and enters the Alarm menu. |
| 8 | Shortcut menu | Access the ATS priority selection, Jump menu, Mode selection, Lamp test. |
| 9 | SEMI-AUTO mode |
The operator or an external signal can join or split the busbar, and connect or disconnect the breakers. The controller cannot automatically do these actions. The controller automatically synchronises before closing a breaker. |
| 11 | Close breaker | Push to close the breaker. In genset applications, the genset is automatically started when you push this button before closing the breaker. |
| 12 | Open breaker | Push to open the breaker. In genset applications, the genset is automatically stopped when you push this button before opening the breaker. |
| 13 | Breaker symbols |
Green: Breaker is closed. Green flashing: Synchronising. Red: Breaker failure. |
| 14 | Breaker selection | Use the navigation arrows to select the breaker you want to control. As shown on the display, the selected breaker is highlighted. |